HOW DO I...
...SET THE TRANSMIT CHANNEL FOR EACH CONTROLLER?
Press the PARM key until the underline cursor is under the desired
Transmit Channel parameter. Press the +/- key to set the desired
channel: 1-16.
...SET THE CONTROLLER NUMBER FOR EACH CONTROLLER?
Press the PARM key until the underline cursor is under the desired
controller number parameter. Press the +/- key to set the desired
controller number: 0-127.
...SELECT THE ANALOG VOLTAGE FOR EACH CONTROLLER?
Press the PARM key until the underline cursor is under the desired
voltage parameter. Press the +/- key to select the desired analog
votage source: 1-4.
...DISABLE THE TRANSLATION FOR A GIVEN CONTROLLER?
Press the DISABLE/ENABLE key (Tog1, Tog2, Tog3, and Tog4) for
the desired controller. Press again to enable the translation.
...SAVE ALL PARAMETERS?
Press the SAVE key. All translation parameters are saved to nonvolatile
EEPROM. They will be recalled at powerup.
...OPERATE THE DEVICE?
Four control voltages (0-5VDC) are connected to the four ADC inputs
(ADC0-ADC3). The digitized voltages are mapped to MIDI controller
messages according to the controller parameters set (voltage source,
MIDI channel, and MIDI controller number). Incoming MIDI messages
are ignored. Running status is implemented.
^ Back to top ^
LCD Screen:
|CNNVCNNVCNNVCNNV|
|XDataXDataXDataXData|
C = MIDI Tranmit Channel (0H-FH), corresponding to MIDI channels
1-16.
NN = MIDI Controller Number (00H-7FH), corresponding to controllers
0-127.
V = Voltage Source (1-4).
X = Controller Disable Indicator (">" = DISABLE).
Data = MIDI Controller Data Transmitted (0-127)
^ Back to top ^